Gary
SE Kansas
I recently was gifted 10 pieces of 30-30 brass and had a hour to mess around in the shop today and I decided to prep the brass to load up tomorrow. First off I decapped the brass and cleaned/uniformed the primer pockets; next I annealed the brass. Next, I full length sized. Took them over to the Lathe and trimmed using a Lee 30-30 trimmer. Not real happy with Lee's trimmer but I went slowly and mic'd repeatedly until I got to 2.029~2.030. Then, still using the Lathe I used my Lyman deburring tool to smooth out the rims.
They're ready for LRP, Powder and cast/PC'd bullet.
They're ready for LRP, Powder and cast/PC'd bullet.