A PIF post (CLOSED)

[Kevin Stenberg]

I have 3 molds I would like to find new homes for. The only 3 requests I have are to pay the shipping, and not turn around and resell, that all molds go to different homes.
Mold 1&2 are the same. They are 7mm weight is about 140 ish gr. with GC, Steel mold blocks, 2 cavity. This was a GB many years ago honchoed by 357 Maximum
Spoken for Mold 3 is VERY ugly on the exterior but casts good bullets. It is a Lee 6 cavity 44 caliber round flat point mold # is 90483. The mold has been Beagled to through at .430. And is drilled so a mold heat Sencer can be used. spoken for

 

[462]

I have 3 molds I would like to find new homes for. The only 3 requests I have are to pay the shipping, and not turn around and resell, that all molds go to different homes.
Mold 1&2 are the same. They are 7mm weight is about 140 ish gr. with GC, Steel mold blocks, 2 cavity. This was a GB many years ago honchoed by 357 Maximum
Mold 3 is VERY ugly on the exterior but casts good bullets. It is a Lee 6 cavity 44 caliber round flat point mold # is 90483. The mold has been Beagled to through at .430. And is drilled so a mold heat Sencer can be used.

Kevin,
I will the Lee mould.

Michael

 

[Kevin Stenberg]

It is yours Michael. If you send me a PM with your snail mail add the mold will probably go out tomorrow.

 

[462]

Thank you, Kevin.

In my hast to post the above, it does not relay my appreciation of your generosity. Also, you can be assured that I will adhere to your stipulations.

PM inbound.

 

[Rockydoc]

Kevin, I would like the 7mm mold.
Rocky

 

[Rockydoc]

Thanks

 

[Kevin Stenberg]

Rocky one of the 7 mm molds is yours. I is brand new the other has MAYBE cast 100 bullets. Please send me your snail mail add.

 

[Ben]

Kevin,

Is the " other " 7 mm mould still available ?
If so, I'd like to have it.

Ben

 

[Kevin Stenberg]

Ben It is yours. Please send me your snail mail add and it will probably go out tomorrow.

 

[Kevin Stenberg]

All molds spoken for Mods please close thread