Elpatoloco
Active Member
I recently purchased my First Mould that cast Hollow points. It also happens to be my first Brass mould. Its from MP.
With his design, there is nothing to keep up with as far as heating a pin seperately. Dang thing just rains slugs. I have less rejects with this mould than any other I have ever cast with.
No snake oil, mould release, anything. Get it burning hot and hammer down. 99% + are within a half grain
With his design, there is nothing to keep up with as far as heating a pin seperately. Dang thing just rains slugs. I have less rejects with this mould than any other I have ever cast with.
No snake oil, mould release, anything. Get it burning hot and hammer down. 99% + are within a half grain
Last edited:
