I made a couple powder dispenser stands.

CWLONGSHOT

Well-Known Member
Powder stands, most I have and have seen are lacking in depth and somewhat height.
When ya have a larger tray of prepped cases, you sometimes cannot complete entire rows without spinning tray and likely missing a case. Plus today most of us are utalizing risers for our presses causing bending to dispense powders.

Last year I made a stand for the Lee 4 Hole as I dont like the LEE powder measurers and this allows my use of the Uniflo or X15 measures I prefer. This allows measure to be held inches above powder die and drops powder i to funnel and then into case very neatly.

I used Black Pipe in 1/2" size and a flange as a base and a 7/8-14 nut all welded together. On this one I didnt weld base allowing the thread to spin measure back out of the way when not needed. I utalized much of the same parts but made this stand ridged.

16B5807A-C5DB-47FF-A175-68B8FDEBADFB.jpeg8CBDE51B-93EE-4C96-A73B-7FD323141545.jpegD62CA0D8-2D75-42A7-BB79-386E91609D27.jpeg16BA37BC-DCE3-49B4-B310-4D496750D8CD.jpegA3CC60BD-0234-4A59-BC21-A86B8B93C7B5.jpegCB9177C7-0528-40C6-BB61-F7977D5BDCEB.jpeg3E25F177-0F6E-4908-8A97-4965BA7A511E.jpeg98D4CD5D-6B7C-458B-8705-AE2377BE5FD9.jpeg3639BD71-CB14-4956-A8BD-76983DA472DB.jpeg
 

CWLONGSHOT

Well-Known Member
Thanks guys! I used ine last night. Looks ta be just what I wanted!!

Also nice ta have the middle of the bench back. ;):p