I wanted to make a mill vise stop but didn’t have any appropriate sized flat stock. Or did I? Why not make a piece?
I found a chunk of round stock that was the right size and parted off a .70 thick section and faced both ends reasonably smooth.
After some work with a 3/4” end mill I had a rectangle roughly the size I wanted with all sides milled smooth.
I found a chunk of round stock that was the right size and parted off a .70 thick section and faced both ends reasonably smooth.
After some work with a 3/4” end mill I had a rectangle roughly the size I wanted with all sides milled smooth.