Neat group

[Mainiac]

I just fired a 5 shot group,at 25yds,,that was nice and round,and it went around my bottom thumb tack,like clockhands,,,1 shot very slightly,nicked the tack.
Aint measured it yet,but i know its under 3/4 inch.
Luckest day a thumbtack,could ever have!
Btw,,when i shoot the lee 105swc,,it shoots 3-4 inches below normal 38 bullets.

 

[Dusty Bannister]

Ooops, I thought this thread was about the guys on the forum.....

 

[fiver]

i need a shave.

slow those 105's down to about 600 fps and see what happens.

 

[Ian]

i need a shave.

slow those 105's down to about 600 fps and see what happens.

...with about three grains of Herco.

 

[CZ93X62]

That is some fine shooting, no doubt about it.

 

[Mainiac]

That is some fine shooting, no doubt about it.

Saved the target,cause the tack hole,is right in the middle!

 

[Mainiac]

i need a shave.

slow those 105's down to about 600 fps and see what happens.

More barrell time,will let them print higher?

 

[fiver]

should.

 

[Bazoo]

I've not shot the 358-105-SWC, thanks for sharing. I'm not surprised though because my experience with the 358-140-SWC is that it's quite accurate. When I was testing it several years ago, I got lots of groups in the 1.5 or less range at 25y with different powders and charges. I worked up a full bore 357 Magnum load using W296.

 

[Mainiac]

I've not shot the 358-105-SWC, thanks for sharing. I'm not surprised though because my experience with the 358-140-SWC is that it's quite accurate. When I was testing it several years ago, I got lots of groups in the 1.5 or less range at 25y with different powders and charges. I worked up a full bore 357 Magnum load using W296.

Ive been meaning to get that mold,,ive always thought it wouldbe a good shooter.