Keeping paralysis by analysis at bay,figured what the hey.... what's the worst thing that can happen? It don't work? Learn from this one and make another....
Took an hr, a letter J drill,and a 5* tapered reamer. Utilizes the little jewelry C frame arbor press. Normally, this press is used for initial GC install on a variety of sizes of bullets.
Interestingly,looking at first pic,that op is now combined in with the nose size... and sorta didn't see that coming. Horseshoe engineering.
Other than hitting my Mark's on the machines.... not a whole lot to say. Pics should explain it all. After sizing,you flip it over and a pin presses bullet out through the bottom (hole goes all the way through wood base).
Took an hr, a letter J drill,and a 5* tapered reamer. Utilizes the little jewelry C frame arbor press. Normally, this press is used for initial GC install on a variety of sizes of bullets.
Interestingly,looking at first pic,that op is now combined in with the nose size... and sorta didn't see that coming. Horseshoe engineering.
Other than hitting my Mark's on the machines.... not a whole lot to say. Pics should explain it all. After sizing,you flip it over and a pin presses bullet out through the bottom (hole goes all the way through wood base).
Last edited: