Kevin Stenberg
Well-Known Member
There was a comment in a thread about aneling aluminum GC. I tried last night to anele the aluminum strips before I punched the checks out.
My process was. Cut the roll of aluminum (4"x 50') into 2' lengths. Put the strips into the oven set at 300 deg. for 1 hour. What do I need to change to anele the strips properly?
My process was. Cut the roll of aluminum (4"x 50') into 2' lengths. Put the strips into the oven set at 300 deg. for 1 hour. What do I need to change to anele the strips properly?