I made a swap a few days ago for this CBE ( Australia ) brass .31 cal. mould.
The mould arrived in the morning mail.
It is a ( factory cut ) plain base mould and had been sent to Erik in Oregon by the owner for Erik's insert bar hp conversion ( great work, not cheap however ).
The mould needed a good cleaning. It is in top flight shape now.
The " as cast numbers" on the nose and drive bands all look good to me.
This mould may have the thickest sprue plate of all of my moulds.
It makes HP bullets just as fast as my 2 cavity moulds that are not HP moulds ? ? ?
Ben
Nose .302 "------------ I'm sizing the drive bands .311"
Lubed, rolled in BLL, sized .311 "
The mould arrived in the morning mail.
It is a ( factory cut ) plain base mould and had been sent to Erik in Oregon by the owner for Erik's insert bar hp conversion ( great work, not cheap however ).
The mould needed a good cleaning. It is in top flight shape now.
The " as cast numbers" on the nose and drive bands all look good to me.
This mould may have the thickest sprue plate of all of my moulds.
It makes HP bullets just as fast as my 2 cavity moulds that are not HP moulds ? ? ?
Ben
Nose .302 "------------ I'm sizing the drive bands .311"
Lubed, rolled in BLL, sized .311 "
Last edited: