Pistolero
Well-Known Member
I will be making a few new pilots for my Forster case trimmer. I wonder if anyone
has a .224, 7mm, 8mm and .358 caliber pilots handy to measure the diameter of
the large part of the pilot?
Based on one that I have, I am estimating standard jacketed bullet diameter minus
0.005 should be about right, but if folks have them handy to get the correct diameter
one one, or a few, that would be helpful.
I think I can fake it if necessary, but other folks may have this info readily available.
Thanks.
Bill
has a .224, 7mm, 8mm and .358 caliber pilots handy to measure the diameter of
the large part of the pilot?
Based on one that I have, I am estimating standard jacketed bullet diameter minus
0.005 should be about right, but if folks have them handy to get the correct diameter
one one, or a few, that would be helpful.
I think I can fake it if necessary, but other folks may have this info readily available.
Thanks.
Bill