358156 hp
At large, whereabouts unknown.
I'm looking for a picture of a specific hollowpoint bullet mould. I think I originally saw it in one of Glens articles or posts. but I don't remember exactly when. It was either a two or four cavity (Lyman?) mould that had been converted to hollowpoint on all cavities, similar to one of Erics "inset bar" design. The major difference was that the bar that carried the hollowpoint pins was square, and the mould had been milled out at the bottom for it in such a manner as to be flush with the base of the mould. The bar could very well have been made from key stock.
I'm not 100% certain that this pic was even on this site, but if I saw it somewhere, there is a high probability someone else here saw it too. Any help with this would be greatly appreciated.
I'm not 100% certain that this pic was even on this site, but if I saw it somewhere, there is a high probability someone else here saw it too. Any help with this would be greatly appreciated.