fiver
Well-Known Member
yes.^^^
bind the case central to the bore of the die, then open the neck.
Ian, it's like the neck up procedure I used with the punch in the size die you told me about.
out of 50 I had like 3 that were over .005 OOO the rest were well under that and closer to .003 that was with a sloppy punch and a hammer opening the necks.
an aligned punch into an aligned hole should produce .002 at the outside.
bind the case central to the bore of the die, then open the neck.
Ian, it's like the neck up procedure I used with the punch in the size die you told me about.
out of 50 I had like 3 that were over .005 OOO the rest were well under that and closer to .003 that was with a sloppy punch and a hammer opening the necks.
an aligned punch into an aligned hole should produce .002 at the outside.