I had searched for a nice clean used mould that was reasonably priced. I finally found one in OK. My Lyman 311008 , 2 cav. mould arrived a couple of days ago from OK. I've had real good luck with this design so far in several .30 cal. rifles , but only had a single cav. mould for this particular design.
Here the bullet is shot at 40 yards out of my Ruger # 1, 30-30.
A 5 shot group.
This one has a few minor lead splatters on the faces. ( Nothing I can't easily remove.) I'd rate the mould at 98% + condition.
Ben
Looks like it was made about 8 yrs. ago :
I got my " new to me " 2 cav. 311008 mould out yesterday and cast some with it. The mould drops cast bullets ( without any sticking ) that are a nice round, .3135" on all bands. Will work out well for my needs. Bullets fall free when the mould is opened.
Here the bullet is shot at 40 yards out of my Ruger # 1, 30-30.
A 5 shot group.
This one has a few minor lead splatters on the faces. ( Nothing I can't easily remove.) I'd rate the mould at 98% + condition.
Ben
Looks like it was made about 8 yrs. ago :
I got my " new to me " 2 cav. 311008 mould out yesterday and cast some with it. The mould drops cast bullets ( without any sticking ) that are a nice round, .3135" on all bands. Will work out well for my needs. Bullets fall free when the mould is opened.
Last edited:
