My journey into 10 with the Highpoint JXP

Mitty38

Mitty38

Well-Known Member
Die set is here. Might get out to test a few this week. Starting off with long shot. Doing 40 SW, 10 mm large primer and 10 mm small. At least get the lader loads made up.
Still have to adjust my sight on the High Point.

Mighty cold so I am not promising anything.
 
Mitty38

Mitty38

Well-Known Member
Well spent about 3 hrs extrapolating, comparing load data. For 40sw and 10mm. With the bullets CW sent me
Thanks again CW.
So have data now for the Lee 410-145.
Mp 360 hollow point, 175-TC Lee, Lyman 200 grain Wad cutter.
Compared data to powder supply.

One thing I noticed is it all works with Blue Dot in both calibers. Plus it is highly praised in all loads of both calibers
I just so happen to have 4lbs or so of Alliant Blue Dot. And 2 of Hercules Blue Dot. Imagine THAT!
So I am going to the "right thing" ignore the Blue Dot for now.

Load with Longshot in Both. And Red Dot in 10mm.
Wanting to cut down on less Versatile powders and Longshot is just not, versatile for other stuff I load. Plus it is just to violent in the 1911 45ACP, for my taste.
I have, lets just say, quite a few opened containers of Red Dot. Kinda lost track on how much, if you know what I am getting at.
The Blue Dot will be saved for when the long Shot is gone.
 
Last edited:
You must log in or register to reply here.