I ordered a 23/64ths 6 flute chucking reamer a few days ago.
The reamer arrived today. I was a bit leary to try it out on a $100 mould, so I decided to use the reamer to remove the g/c shank
from one of the cavities of a $20, 2 cav., Lee, 358, 200 gr. mould.
One cavity is now PB, one cavity is left as a g/c design.
Ben
The reamer arrived today. I was a bit leary to try it out on a $100 mould, so I decided to use the reamer to remove the g/c shank
from one of the cavities of a $20, 2 cav., Lee, 358, 200 gr. mould.
One cavity is now PB, one cavity is left as a g/c design.
Ben
Last edited: