Bill,sharpen a tungsten to a serious "point"...... then go find a very acute inside angle on tubing or sumthin. Watch what happens to the arc. Until the tip gets nubbed,in this case,under fire...... good luck. You just have to be aggressive "chunkin" the filler in. I love gas welding.... mig? not so much,well the flux core is nice for outside. Tig is my favorite because of the low amp capabilities. Was welding a custom air cleaner on an air compressor yesterday. Small beads on tubing/gauge metal..... and welding 1/4" nuts to gauge stuff. Can't beat it with a stick. Oh yeah,used an old oval John Deere Kawasaki filter as the donor.
Go find some silicon bronze Tig rods..... snag some stainless 309 too. These are like aces up your sleeve. Not everyday rods but will get you out of a bind in several areas.
Go find some silicon bronze Tig rods..... snag some stainless 309 too. These are like aces up your sleeve. Not everyday rods but will get you out of a bind in several areas.