Mowgli Terry
Active Member
I just got a return email from Erik Ohlen concerning a mold conversion. The mold is to go into the mail next week. The hollow point mold is an Ideal#358439 (358429 HP). The original pin is missing. That pin is to be replaced. Plans are to also get a cup point pin. The mold is used but not beat up. I plan to use an alloy of 8 BH or so.
I'd like some comments and direction on this project. Also, comments on the merits of casting these bullets with a cupped point. Am I missing the mark?
I'd like some comments and direction on this project. Also, comments on the merits of casting these bullets with a cupped point. Am I missing the mark?