CWLONGSHOT
Well-Known Member
Powder stands, most I have and have seen are lacking in depth and somewhat height.
When ya have a larger tray of prepped cases, you sometimes cannot complete entire rows without spinning tray and likely missing a case. Plus today most of us are utalizing risers for our presses causing bending to dispense powders.
Last year I made a stand for the Lee 4 Hole as I dont like the LEE powder measurers and this allows my use of the Uniflo or X15 measures I prefer. This allows measure to be held inches above powder die and drops powder i to funnel and then into case very neatly.
I used Black Pipe in 1/2" size and a flange as a base and a 7/8-14 nut all welded together. On this one I didnt weld base allowing the thread to spin measure back out of the way when not needed. I utalized much of the same parts but made this stand ridged.
When ya have a larger tray of prepped cases, you sometimes cannot complete entire rows without spinning tray and likely missing a case. Plus today most of us are utalizing risers for our presses causing bending to dispense powders.
Last year I made a stand for the Lee 4 Hole as I dont like the LEE powder measurers and this allows my use of the Uniflo or X15 measures I prefer. This allows measure to be held inches above powder die and drops powder i to funnel and then into case very neatly.
I used Black Pipe in 1/2" size and a flange as a base and a 7/8-14 nut all welded together. On this one I didnt weld base allowing the thread to spin measure back out of the way when not needed. I utalized much of the same parts but made this stand ridged.
