I have 200 amp to the house. When I got the lathe I had them run a 60 amp subpanel in the garage. It sits right above and to the side of my casting bench. They can now just make a run from that panel for the mill.
I am not overly worried as I won't ever be using both the lathe and the mill at the same time.
I am not the best with electrical so when a I ran a few outlets for the casting bench I used two outlets with each on a separate breaker. The pot draws a bit of power so I use the other outlet for the fan, lights, and what not.
I am not overly worried as I won't ever be using both the lathe and the mill at the same time.
I am not the best with electrical so when a I ran a few outlets for the casting bench I used two outlets with each on a separate breaker. The pot draws a bit of power so I use the other outlet for the fan, lights, and what not.