311334GC -308 Win Test

[quicksylver]

I just rechecked the Lyman mold chart from Buffalo ..it shows the 311334 to weigh in at 190 sans check and the 311332 at 180 sans check....
mine are 4-4-92
I can send some PB if you would like to try them.....
Just PM me your address....Dan

 

[Sendaro]

Dan, I'd like to try them before I order a mold. Will send you my address. Thanks Sendaro

 

[Sendaro]

Thanks, I believe i have posted that information in the right place. Let me know if you have it.

Sendaro

 

[Sendaro]

By Joe I guess I put that info in the wrong place. Bran deleted it. How do I contact you by PM without your email address?

Sendaro

 

[Rick]

Sendaro, a PM on this forum is called a conversation instead of a PM. Very simple, just click on the persons name under their avatar, a window pops up, in that window click on "start a conversation". Add a conversation title, enter your message and send.

 

[Sendaro]

Rick, Thank you for the info and help. Sendaro

 

[quicksylver]

Whoops my bad...I should have said how to contact me

 

[Sendaro]

No problem, just my ignorance! However I'm learning.

 

[fiver]

great conversation guy's.
and no I'm not here to angle it off in another direction.
I'm just following along, thinking about how we used to have to write this stuff down on paper and give it 4 days to get where it was going, then wait 4-5 more to get a reply back.

 

[Sendaro]

That's the way that Harvey Donaldson did it. What took him months we get done in hours. Great to be alive in this age!!! I'm sure Harvey would have loved it.

Sendaro

 

[popper]

Just to make a comment on alloy hardness - this is AR BO 145gr PB @ 50, clocks ~ 2k fps. Notice vertical from 2%(upper 30's BHN) vs same load (on the right) of 1% (upper 20's BHN). was just testing alloys, not great shooting but an observable difference. Nose is in the bore but nowhere near the lands. Others are jacketed.
http://i1078.photobucket.com/albums/w491/popper29/SCN_0107_zpsqoib6udq.jpg